ABB FPBA-01 Instrukcja Obsługi Pobierz pdf (Strona 31)

Starting up fieldbus communication and programming the ABB PLC (one-drive system)

Start-up flowchart

The steps of the start-up procedure are presented below. Perform the steps from first

to last.

No. Task Description / See instruction

ELECTRICAL INSTALLATION In this section, you wire the equipment used in this programming

example.

1 Connect the PC RJ-45 cable to

drive terminal X7.

ACSM1-04 Drive Modules Hardware Manual (3AFE68797543

[English])

Page 34

2 Connect the PLC fieldbus master

(CM572-DP) to the fieldbus

adapter module (FPBA-01) of the

drive.

Installation of the TA510-CASE, page 34

3 Connect the PC serial port (COM)

to the PLC programming port.

OR:

Connect the PC Ethernet port to

the PLC Ethernet port with an RJ-

45 Ethernet cable.

OR:

Connect the PLC serial port to the

PC USB port with a TK503

programming cable

Installation of the TA510-CASE, page 34

TK503 programming cable order code: 1TN968901R1100

SOFTWARE INSTALLATION In this section, you install the programming tools.

1 Install the DriveStudio PC tool if

not yet installed.

Installing the DriveStudio PC tool, page 35

2 Install the AC500 Control Builder

PS501 software.

Installing the AC500 Control Builder PS501 software, page 35

3 Install the PS551-MC Motion

Control library.

Installing the PS551-MC Motion Control Library, page 37

4 If needed, install additional GSD

files and libraries.

Installing additional GSD files and libraries, page 38

PROGRAMMING In this section, you set up the communication between the drive

and the PLC and make the PLC program that controls the drive

through fieldbus.

– – – O N E - D R I V E S Y S T E M – – –

1 Set the drive control program

parameters.

In this section you set the drive parameters needed for

communication with the FPBA-01 fieldbus adapter module.

Setting the drive control program parameters, page 40

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 133 134

Komentarze do niniejszej Instrukcji

Brak uwag

ABB FPBA-01 Instrukcja Obsługi Strona 31

Komentarze do niniejszej Instrukcji